The innovative new PAC RP4-VW11 radio replacement interface comes pre-loaded with amplifier retention and steering wheel control (SWC) software, navigation based output signals and other features that save time and money during installation.
Radiopro4 PAC RP4-VW11 Stereo Replacement Interface
Data controlled accessory and navigation outputs
Built in pre-programmed steering wheel control (SWC) retention
Retains factory amplifier
Note: In Premium Amplified Systems only two input channels can be used from the aftermarket radio, therefore there will be no fading capability of the aftermarket stereo.
Provides factory RSE activation
Retains warning chimes
Retains rear seat radio controls
Rear seat entertainment activation
Rear seat entertainment A/V ready
No programming required
Accessory 12-volt output
2002-2005 Vehicles: In these year vehicles the RP4-VW11 does not provide a Reverse output trigger. This signal is unavailable on the data bus. You must be replacing a factory Double-DIN radio. If the vehicle came equipped with a Single-DIN radio, the RP4-VW11 is not compatible.
2004-2007 Touareg: Does not retain digital audio amplified system seen when the vehicles is equipped with factory navigation radio
In Premium Amplified Systems only two input channels can be used from the aftermarket radio, therefore there will be no fading capability of the aftermarket stereo.